Can I install a Fuel Pressure Regulator myself?

• Related Articles

• Why is it important to check the Air-Fuel ratio while setting the desired boost pressure?

  Any increase in boost pressure can cause the engine to run “LEAN”, resulting in possible engine damage.

• How much boost can a valve hold?

  Our valves are not rated by the amount of boost pressure that they can hold. A good rule of thumb is that if the hose supplying air into the top chamber of the valve is large enough to supply an adequate volume of air, then the valve itself should ...

• After installing the eBoost2 my engine is over-boosting/underboosting.

  • Check that the eBoost solenoid is installed correctly. • Ensure the factory boost control solenoid is not connected in the hose between the pressure source and the wastegate actuator • Ensure the length of the wastegate actuator rod has not been ...

• What is the purpose of a boost controller?

  Boost controllers increase the boost generated by the turbocharger above what the wastegate would usually allow with its designed spring pressure/rate. Additional features are designed into the electrical units we produce. However, the primary ...

• What hose connection method should I use for my electronic controller?

  This question is best directed to the person doing the system design and tuning on the vehicle. The intended boost range that you’d like to run on the vehicle and the spring pressure being used in the wastegate are key factors for this discussion.