I’ve installed a VeePort in my car and despite all the tuning the car still stalls.

• Related Articles

• I’ve installed a Supersonic and now my engine is dipping below normal idle and stalling.

  • Check the vacuum hose for splits, cracks, loose connection, kinking or any obstruction – old or fatigued hose may collapse under vacuum causing an obstruction • With the engine running remove the vacuum/pressure hose from the nipple in the cap of ...

• I’ve accidentally zeroed all the dials, what are the factory settings on the FCD2?

  Before setup, the unit should be set to the following settings, Clamp=10, Release=10.

• What boost controller should I get?

  This complex question requires additional information about your intended use for the vehicle and the controller. Mechanical boost controllers are simple to operate and extremely reliable, with little maintenance and tuning required. Electronic ...

• What hose connection method should I use for my electronic controller?

  This question is best directed to the person doing the system design and tuning on the vehicle. The intended boost range that you’d like to run on the vehicle and the spring pressure being used in the wastegate are key factors for this discussion.

• How much boost can a valve hold?

  Our valves are not rated by the amount of boost pressure that they can hold. A good rule of thumb is that if the hose supplying air into the top chamber of the valve is large enough to supply an adequate volume of air, then the valve itself should ...