The dials on my FCD2 do not go all the way around.
The adjustment dials do not turn 360O, they start at 1 and finish at 10. Do not force them past these points as this will damage your FCD2.
Related Articles
My valve is not functioning the way that it should be. What should I do?
The first step would be to perform some basic inspections on the valve and try to establish what potential causes might exist (such as a leak or an incorrect spring). If the valve is a piston-type valve and has not been maintained (cleaned and lubed) ...
I’ve accidentally zeroed all the dials, what are the factory settings on the FCD2?
Before setup, the unit should be set to the following settings, Clamp=10, Release=10.
What is the proper connection method for the eBoost2 solenoid into an external wastegate?
There is no “proper” way, just start with the basic hook up method as per the instructions and if you don’t get the desired effect, try the other hookup methods as outlined in the fitting instructions.
How can I test my wastegate to make sure it is working properly?
Although you can perform a “bench test” of a wastegate to confirm that it is cycling properly and not seized, this bench test will not offer accurate results in regards to the amount of air required to open the wastegate. It is important to keep in ...
Are there any ways to test my boost controller to make sure it is working properly?
Yes, we offer spare parts and accessories for our boost controllers. This includes mounting brackets, toggle switches, wire harnesses, and more. These are all available in the “Spares and Accessories” portion of our website.