What is the proper connection method for the eBoost2 solenoid into an external wastegate?

• Related Articles

• How are the eBoost 2 and the eBoost Street different?

  The eBoost Street and E-Boost 2 perform many of the same base functions, but some differences are. The eBoost Street is capable of storing 2 boost settings which can easily be switched by using the gauge knob/button or by use of an external switch ...

• Will fitting an external Wastegate require any custom fabrication?

  Yes, fitting an external wastegate will require fabrication of a custom manifold and or modification to an exhaust manifold.

• What hose connection method should I use for my electronic controller?

  This question is best directed to the person doing the system design and tuning on the vehicle. The intended boost range that you’d like to run on the vehicle and the spring pressure being used in the wastegate are key factors for this discussion.

• How can I test my wastegate to make sure it is working properly?

  Although you can perform a “bench test” of a wastegate to confirm that it is cycling properly and not seized, this bench test will not offer accurate results in regards to the amount of air required to open the wastegate. It is important to keep in ...

• Do I need one solenoid for my electronic boost controller, or is two preferable?

  This question is best directed to the person doing the install and configuration of the electronic boost controller. In many cases, the primary consideration in answering this question is which option will allow for a greater reduction in the length ...