Boost Control
What is the proper connection method for the eBoost2 solenoid into an external wastegate?
There is no “proper” way, just start with the basic hook up method as per the instructions and if you don’t get the desired effect, try the other hookup methods as outlined in the fitting instructions.
I'm re-mounting my eBoost 2 and I don't want to lose the current setup. Will the settings be retained with the unit unplugged?
No, you won’t lose anything, but if you are worried, take 5-10 minutes and note down all your settings. it’ll be helpful if you do accidentally change something.
After installing the eBoost2 my engine is over-boosting/underboosting.
• Check that the eBoost solenoid is installed correctly. • Ensure the factory boost control solenoid is not connected in the hose between the pressure source and the wastegate actuator • Ensure the length of the wastegate actuator rod has not been ...
How do I wire up the Single/Dual Stage Boost Controller?
The updated Fitting Instructions include a wiring guide. You can download them from the “INSTRUCTIONS” section of this website.
I’m experiencing excessive/fluctuating boost with the Boost Tee.
(The following answers also apply to Dual and Single Stage Boost Controllers) • Check that the boost controller is installed so that the arrow points toward the wastegate actuator. • Check the joining hoses for splits, cracks or loose connection and ...
Are there any ways to test my boost controller to make sure it is working properly?
Yes, we offer spare parts and accessories for our boost controllers. This includes mounting brackets, toggle switches, wire harnesses, and more. These are all available in the “Spares and Accessories” portion of our website.
Are spare parts available for the units?
Yes, we offer spare parts and accessories for our boost controllers. This includes mounting brackets, toggle switches, wire harnesses, and more. These are all available in the “Spares and Accessories” portion of our website.
What hose connection method should I use for my electronic controller?
This question is best directed to the person doing the system design and tuning on the vehicle. The intended boost range that you’d like to run on the vehicle and the spring pressure being used in the wastegate are key factors for this discussion.
Do I need one solenoid for my electronic boost controller, or is two preferable?
This question is best directed to the person doing the install and configuration of the electronic boost controller. In many cases, the primary consideration in answering this question is which option will allow for a greater reduction in the length ...
How are the eBoost 2 and the eBoost Street different?
The eBoost Street and E-Boost 2 perform many of the same base functions, but some differences are. The eBoost Street is capable of storing 2 boost settings which can easily be switched by using the gauge knob/button or by use of an external switch ...
What are the benefits of an electronic boost controller?
Electronic boost controllers have many benefits not found in manual controllers. Our electronic boost controllers have an Overboost Protection function which acts as a safety feature. This is to prevent, boost over your desired maximum. They also can ...
What boost controller should I get?
This complex question requires additional information about your intended use for the vehicle and the controller. Mechanical boost controllers are simple to operate and extremely reliable, with little maintenance and tuning required. Electronic ...
What is the purpose of a boost controller?
Boost controllers increase the boost generated by the turbocharger above what the wastegate would usually allow with its designed spring pressure/rate. Additional features are designed into the electrical units we produce. However, the primary ...